针对规定路面设计温度选用的结合料。实验室性能涵盖原样及模拟老化后材料；气候、交通、可靠度和项目标准决定选型。 两个温度值表示规定的高温和低温等级，并非交货当天的气温。请提供完整PG牌号和项目试验要求，以同一规范评估所提议的结合料。
这些是SRNT目录的参考限值，不是批次实测结果或COA。每次询价须确认可供性、标准版本及合同限值。
技术指标名称和目录脚注保留英文，以确保含义准确。
| 性质／条件 | 单位 | 参考限值 | 测试方法 |
|---|---|---|---|
| PAVEMENT DESIGN TEMPERATURES | |||
| Average 7-day maximum pavement temperature | °C | 70 | Grade designation |
| Minimum pavement design temperature | °C | -10 | Grade designation |
| ORIGINAL BINDER | |||
| Flash point (Cleveland open cup) | °C | ≥230 | AASHTO T48 |
| Rotational viscosity at 135°C | Pa·s | ≤3.00 | AASHTO T316 |
| DSR, G*/sinδ at 70°C, 10 rad/s | kPa | ≥1.00 | AASHTO T315 |
| AFTER RTFO AGING | |||
| Mass change (absolute value) | mass % | ≤1.00 | AASHTO T240 |
| DSR, G*/sinδ at 70°C, 10 rad/s | kPa | ≥2.20 | AASHTO T315 |
| AFTER PAV AGING OF RTFO RESIDUE | |||
| PAV conditioning temperature¹ | °C | 100 / 110 | AASHTO R28 |
| DSR, G*·sinδ at 34°C, 10 rad/s | kPa | ≤5000 | AASHTO T315 |
| BBR creep stiffness, S at 0°C, 60 s | MPa | ≤300 | AASHTO T313 |
| BBR m-value at 0°C, 60 s | - | ≥0.300 | AASHTO T313 |
| Physical hardening at 0°C, 24 h | - | Report | AASHTO T313 |
| Direct tension² at 0°C, 1 mm/min | % strain | ≥1.0 | AASHTO T314 |
¹ PAV conditioning follows the specified climatic protocol; 110°C may be required for desert climates.
² Where permitted by the contract specification, direct tension can replace the stiffness limit when S is 300-600 MPa; the m-value requirement still applies.
Reference PG profile. The contract standard and edition govern acceptance. M332 / MSCR traffic requirements and modification status are reviewed separately if requested.
DSR: dynamic shear rheometer. BBR: bending beam rheometer. RTFO: rolling thin-film oven. PAV: pressure aging vessel.
